| SOLUS RD SERIES 4.1 WEDGE |
 |
|
|
The rearward 2/3 of the bounce contour of a conventional Sarazen
wedge sole is repositioned upward and behind the leading edge of the
club head, the bounce angles are increased slightly, and a camber is
added to the rear of that sole contour extending from heel to toe.
This improved sole contour lowers the leading edge (more than 1/8 inch
lower than the industry sales leaders) for better set-up and play on
square-faced shots from tight lies, downhill lies, and buried bunker
shots. Yet, an opened club face orientation for bunker explosion shots
reveals an even greater bounce surface area (two 18-degree bounce
surfaces) for improved sand play.
The sole contour camber extending from heel to toe creates a negative
bounce area for a "pro-grind" relieved heel area to play open-faced lob
shots without a dangerously raised leading edge.
This same camber also creates a "keel effect" for the club head in an
area of maximized bounce contour directly below the C.G., so that
contact with the playing surface at impact does not miss-align the club
head.
The C.G. for the club head is also slightly raised and moved rearward
with the design of the crescent cut sole contour. This higher C.G.
increases ball spin rates and improves trajectory management
capabilities. The more rearward C.G. enhances gear-effect and increases
the Moment of Inertia of the club head for better distance and
directional performance on off-center hits. |
| Club |
Loft |
Length |
Head |
Shaft |
Grip |
| AW |
51° |
35" |
Carbon Steel with Black Oxide Finish |
True Temper Steel |
Winn V-17 Series Wrap |
| SW |
56° |
35" |
Carbon Steel with Black Oxide Finish |
True Temper Steel |
Winn V-17 Series Wrap |
| LW |
61° |
35" |
Carbon Steel with Black Oxide Finish |
True Temper Steel |
Winn V-17 Series Wrap |
|
